Tuning a website for speed can be done at different levels. Optimizing at the (web) server level has the benefit of affecting all sites and applications. Mod_pagespeed runs as an Apache module. HTML/JavaScript minification and image recompression are just some of its tricks, and it gets better with every release.
How to Install and Configure mod pagespeed Module with Apache on Ubuntu 18.04 LTS
In order to be able to access the admin pages you need to configure /etc/apache2/mods-enabled/pagespeed.conf to allow access from your IP address. You also need to turn off the rewrite engine if you are using this in conjunction with WordPress:
ngx_pagespeed is an open-source Nginx module that automatically applies best practices to optimize website front-end performance. In this tutorial, I will be showing you how to install PageSpeed module with Nginx on Ubuntu 22.04 and Ubuntu 20.04 server. We are going to compile ngx_pagespeed as a dynamic module, which will simplify ongoing maintenance.
If the image on your web page failed to load in web browser and you see the following error message in your web server log, then you need to add the pagespeed FetchHttps enable; directive in Nginx configuration file to make the PageSpeed module fetch HTTPS resources directly, without going to HTTP first.
I hope this tutorial helped you install PageSpeed module with Nginx on Ubuntu 22.04 and Ubuntu 20.04. You may also want to set up the ModSecurity web application firewall to protect your website from hacking.
In this article we have reviewed 5 tips that will help you tune the Apache web server and increase its performance. In addition, you should remember that optimization and performance without security is pointless, so you may want to refer to the install mod_pagespeed to improve webserver performance and Apache hardening tips article in Tecmint.com as well.
You can configure Mod_pagespeed module different ways. Either you can use the default pagespeed.conf file to configure it for the whole server, or you can put your all of its settings in your virtual host directive.
On Plesk servers running on Red Hat Enterprise Linux 8 and its derivatives with the Extra Packages for Enterprise Linux (EPEL) repository configured, installing AWStats packages from the EPEL repository no longer results in AWStats being non-functional.(PPPM-13617)
and then carefully downgrade each of them to the version from official repository. You have to use Synaptic for this. Or by using commands like sudo apt-get install libssl1.1=1.1.1-1ubuntu2.118.04.7 libssl1.1:i386=1.1.1-1ubuntu2.118.04.7 .
It doesn't matter that you upgraded in 2013 before.Now have you upgraded to 1.7.8.1?Modules compatible with the old version of Prestashop, the override for the old version of Prestashop may not work properly for the new version of Prestashop and the PHP version.It would be good to turn off the pagespeed module and clear the cache.I haven't read anywhere if the e-shop was linked to StoreManger?Furthermore, I did not read anywhere since the problem appeared, what module was installed, what modification was performed, etc ... 2ff7e9595c
Comments